Seal a Pavered Driveway
Use H&C's Paver Sealer Natural to lock in the joint sand between pavers, as well as inhibit weed growth. Easy to apply for beautiful, long-lasting results!
RECOMMENDED PRODUCT AND HOW-TO:
H&C® Paver Sealer Natural Water-based
-
Product Supplies
- Paint brush, roller covers, frames
- Paint tray, liner
- Low pressure pump-up sprayer: nozzle not to exceed 20 psi (pounds per square inch)
-
Product Preparation
This product should be applied to a clean surface that is free of dirt, oil, grease and mildew. H&C Cleaner Degreaser will remove light soils. Follow label instructions thoroughly. All excess joint sand should be swept off the surface prior to application.
Do not apply Paver Sealer Natural if rain is imminent within 12 hours of application.
-
Product Application
First Coat: The most efficient method of application is with a low-pressure pump type sprayer but can be brushed or rolled if desired. Nozzle pressure should not exceed 20 psi. Apply the sealer liberally and evenly flood the paving stone joint to achieve maximum joint sand stabilization.
If working with vertical surfaces, such as retaining walls, coat in the same manner above, working from the bottom of the wall to the top. Allow the sealer to run down the surface 8 to 10 inches always maintaing a wet edge to prevent "lapping".
Second Coat: If desired, apply within 1-2 hours of first coat application. Do not over apply this product as the surface may become slippery. Do not apply more than 2 coats of H&C paver sealer. In the final coat, feel free to add H&C's SharkGrip™ Slip Resistant Additive for a more slip resistant surface.
Drying time:
Touch: 1 hour
Recoat: 1-2 hours
Light Traffic: 24 hours
Heavy Traffic: 48 hours
