Shield-Crete Glaze

H&C® Shield-Crete® Acrylic Clear Glaze

H&C Shield-Crete Acrylic Clear Glaze is a low VOC (Volatile Organic Compounds) clear waterborne acrylic sealer.  It is designed to lock in the flakes of H&C Shield-Crete Epoxy Concrete Garage Floor Coating.  The can is filled to cover a 2 1/2 car garage, or 400 square feet, this easy to apply, low odor product will provide superior protection and added gloss.  

Where to Use

  1. Garage floors
  2. Commercial floors
  3. Covered patios and landings
  4. Basement and laundry room floors 

Key Advantages

H&C Shield-Crete Acrylic Clear Glaze is a high gloss, easy-to-use protective coating designed specifically for use on garage floors.  It resists common chemical agents while maintaining a protective barrier for the decorative flakes in the H&C Shield-Crete Epoxy kit.  It makes it easier to keep your garage floor clean as well, long after you've completed the project for years to come.  

Product Data Sheet

  1. Product Supplies

    1. Roller cover, high quality 1/4" - 3/8" nap roller cover
    2. Brush, if desired, a nylon/polyester brush
    3. Paint tray and tray liner

  2. Product Preparation

    Install at temps between 60ºF & 90ºF and when relative humidity is less than 80%. Allow H&C Shield-Crete Epoxy Concrete Garage Floor Coating to dry for 12-24 hours before application of the Glaze Coat.  Just broom sweep or use a leaf blower to remove any lose dirt or debris that fell overnight.

  3. Product Application

    Brush and/or roll the glaze using 1/4" to 3/8" nap roller cover.  Typically just a roll-on application is necessary, but for hard to reach areas, a brush may be needed.

     

     

    Stir in the non skid additive packet included in the H&C Shield-Crete® Epoxy kit.  H&C's SharkGrip™ can also be used.  Periodic stirring during the application is needed to ensure uniform application of the non-skid additive.

     

     

    The Glaze will roll on milky white which makes it easy to see which areas have been coated, but dries to a beautiful gloss shine in about an hour.

     

     

    If a second coat is desired allowed a minimum of 4 hours between applications.

     

    Drying time:

    To Touch: 1 hour

    Recoat: Minimum 4 hours

    Light traffic: 12 hours

    Heavy traffic: 72-96 hours

     

sign up to receive e-newsletter