Texture Resin

H&C® Texture Resin & Bond Coat

H&C Texture Resin & Bond Coat is a polymer admixture which can be used for cohesion (bonding) and strengthening concrete/ masonry surfaces. Upgrade unsightly concrete decks, patios, driveways, hallways and walkways etc.,  with H&C Texture Resin!  It provides a decorative, strengthened surface which is durable, resists staining, U-V rays, abrasions and mildew.

Where to Use

  1. Patios/walkways
  2. Garage floors
  3. Concrete driveways
  4. Pool decks

Key Advantages

Used together, with H&C Dual Component Texture, this 2-component system is ideal for southern climates.  H&C Texture Resin and Dual Component Texture is low maintenance, abrasion resistant and is ideal for any application. Excellent adhesion promoter. Low maintenance, abrasion resistant.

Product Data Sheet

  1. Product Supplies

    1. 5 gallon pail
    2. Drill
    3. Mixer
    4. Pump or HVLP sprayer

  2. Product Preparation

    Surface should be free of foreign soils. Oil, grease and mildew should be removed with the appropriate cleaning substance. Acid etch/wash when porosity is in question. Rinse thoroughly and allow to dry until there is no standing water (Deck Mix may be applied to a damp surface). Any repairs should be completed at this time.

  3. Product Application

    When used in the H&C Dual Component Texture or as a bond coat adhesion promoter, for the stampable overlay, mix 5-gallons of resin to 10-gallons of water (1:2 ratio respectively).

     

    Mixing Instructions: Mix 1 to 1 1/2 gallons of resin/water solution to one 50 lb bag of Mix. Determine the amount of resin needed for the job and mix with water (ie: 5 gal texture resin mix with 10 gal of water). Pour 1 - 1 1/2 gal of resinwater mix into separate (clean) pail and add Texture Resin Mix (always start with the liquids and add the dry goods). Using a 1/2” 5 amp variable speed drill and mud mixer (paddle type), mix thoroughly until proper consistency is achieved (pancake batter). Allow blended mix to set five to ten minutes (in shaded area). The mix will reach an initial false/preset; re-mix, adding small amounts of resin mix until original consistency is achieved. When applied through a standard spray-on method, the approximate cover rate is approximately 150 sq. ft., per 50 lbs of Texture Resin Mix. When skim coating/ troweling, the approximate cover rate of 50 - 60 sq. ft. is to be expected. Note: Mix is heat sensitive and should not be applied at temperatures below 55°F or above 90°F. When applied in extremely hot temperatures, mist (no puddling) the surface with water periodically.

     

    Bond Coat: Using same ratios and application methods as with the texture resin, (5 gallon resin mix with 10 gallons of water, for example), use this Bond Coat to ensure H&C® Stampable Overlay adheres soundly to the original slab of concrete. Allow Bond Coat to dry to the touch before applying H&C® Stampable Overlay. This will vary by conditions and regions, but typically about an hour to dry.

     

    Application: Spray uniformly using any pump up or HVLP sprayer where H&C® Stampable Overlay is to be used.

sign up to receive e-newsletter