H&C® Infusion Water-Based Sealer

H&C Infusion Water-Based Sealer is an emulsion of modified acrylic resin.  This unique acrylic emulsion is a premium clear durable sealer that is designed to go over Infusion Reactive Concrete Stains. 

Where to Use

H&C Infusion Water-Based Sealer is for commercial, industrial, or residential uses over Infusion Reactive Acid Stains.  Sealer may also be used by itself. 

Key Advantages

This product contains U.V. inhibitors that provide a non-yellowing film.  It can be used for interior or exterior applications and exhibits superior resistance to oil and gasoline. It will apply milky white but dry to a clear glossy shine. 

Product Data Sheet

  1. Product Supplies

    • Brush
      Use a synthetic bristle brush.
      Use a _"-3/8" nap lambs wool roller.
      Tip………………………... .013"-.015"

     ** If using the Solvent-Based Sealer, you will need xylene for clean-up.

  2. Product Preparation


    Infusion Reactive Stain residue MUST be removed prior to applying sealer.
    Surface must be dry 24 hours after final rinsing of removing residue.
    Read all cautions and MSDS before any work is started.


  3. Product Application

    Always do a test area to ensure compatibility. H&C Infusion Water-Based Sealer is best applied by spray. DO NOT REDUCE. The sprayer must be clean and dry. Apply by low-pressure sprayer with neoprene fittings.


    Wait at Least 24 hours after removing residue. Apply under dry conditions only. Application to a damp surface may cause a hazy appearance or loss of adhesion. Air and surface temperature should be between 50° and 90°F for 24 hours following application. It's important not to overwork the product, as to not trap air, which will effect dry time as well as the final appearance. 


    Dry Time
    Drying Time: @ 77°F 50% RH
    Temperature and humidity dependent.

    Touch 40 minutes Recoat 4 hours Heavy Traffic 48 - 96 hours